Panasonic PT-F100NT User Manual
25
Other operations for connection
l
When using “Search by IP address”
Enter the IP address (including its periods).
Example: 192.168.10.100
B
Select [Search by IP address]
l
When using “Search by domain name”
A
Enter the domain name.
B
Select [Search by domain name].
l
When using “Search by ID”
A
Enter the ID.
B
Select [Search by ID].
Enter the information of the projector you want to
search for, and select the search criteria.
2
Click [
] at the <Projector Search> window.
<Other search> window appears.
1
Apart from “Easy Wireless Set Up” (See page 13), there are 3 other ways to search for and connect to a projector, namely
“Search by IP address”, “Search by domain name”, and “Search by ID”.
These methods can be used if you cannot search using “Easy Wireless Set Up”.
• Search by IP address
Search for and connect to a projector from the IP address
※
.
The projector that you want to connect to must have a network number of [USER1]-[USER3] and
must have the IP address set. (See pages 47, 48)
• Search by domain name Search for and connect to a projector from the domain name
※
.
The projector that you want to connect to must have a network number of [USER1]-[USER3] and
must have the IP address set. (See pages 47, 48)
※ “Glossary” (See page 64)
• Search by ID
Even if there are two or more projectors with the same name, an ID ([Proj] + 4-digit number) is
assigned to each projector to enable the projectors to be identified.
A search for the projector of the specified ID is carried out from among the projectors that are
presently switched on, from all network numbers other than [USER1]-[USER3].
It is necessary to know ID in advance. When input selection is switched to [NETWORK] on a
projector, the ID appears on the upper right of the projection screen for approximately 5 seconds. If
you write down the ID displayed in the [ID] column of the <Projector Search> window in advance,
you can search a projector by the ID from next time.
A [ ] mark is displayed for projectors that have passwords set.
The window shown to the right appears to establish a connection. Enter the password for the projector
and click [OK].
(Password setting → See page 51)
• Click [CANCEL] at the <Password Input> window to return to launcher canceling the connection (See page 28).
• When an incorrect password is entered, an error message appears.
Click [OK] to return to the <Password Input> window and enter the correct password again.
Operations when password entry is required for connection
Other search