Panasonic TQBJ 0268-5 User Manual
64 –
ENGLISH
How to use ADVANCED MENU (continued)
Press ENTER.
2.
The “CLAMP POSITION” screen will be
•
displayed.
CLAMP POSITION
POSITION
POSITION
ADJUST
1
Press
◄► to adjust.
3.
The value changes from 0 to 255.
•
The optimal value for the clamp position
•
adjustment
If dark areas are crushed:
The optimal value is the point where the dark
area is best improved.
If the dark areas are displayed in green:
The optimal value is the point where the green
areas become black and the crushing effect is
rectified.
If dark areas are crushed:
The optimal value is the point where the dark
area is best improved.
If the dark areas are displayed in green:
The optimal value is the point where the green
areas become black and the crushing effect is
rectified.
Note
The clamp position can be adjusted only when the
•
RGB signal input is applied with RGB1 and RGB2 IN.
Edge blending adjustment
This projector has the function to hide the seams for
multi-screens.
multi-screens.
Press
▲▼ to select “EDGE
1.
BLENDING”.
CLAMP POSITION
EDGE BLENDING
FRAME DELAY
OFF
DEFAULT
Press
◄► to switch “EDGE
2.
BLENDING”.
The setting will change as follows each time
•
◄► is pressed.
OFF
ON
USER
OFF:
•
When the multi-screens are not going to be used.
ON:
•
When the tilting inside the unit is to be used for the
tilting of the edge blending area.
tilting of the edge blending area.
USER:
•
When a specific tilting is to be used for the tilting
of the edge blending area. (Separate software is
required to establish these settings. Consult your
dealer.)
of the edge blending area. (Separate software is
required to establish these settings. Consult your
dealer.)
Press ENTER.
3.
The “EDGE BLENDING” screen will be
•
displayed.
EDGE BLENDING
UPPER
UPPER
START
ON
0
Press
▲▼ to specify the area to
4.
be adjusted.
To joint the top:
•
set “UPPER” to “ON”.
To joint the bottom
•
: set “LOWER” to “ON”.
To joint the left:
•
set “LEFT” to “ON”.
To joint the right:
•
set “RIGHT” to “ON”.
Press
◄► to toggle “ON” and
5.
“OFF”.
Press
◄► to adjust the
6.
compensation width and start
position.
position.
To display the adjustment
marker
Press
▲▼ to select “MARKER”.
7.
RIGHT
MARKER
BRIGHT ADJUST
OFF
OFF
OFF
Press
◄► to select “ON”.
8.
A marker for adjusting the picture position
•
appears. The optimal point is the position
where the red line of one frame overlaps the
green line of the other frame.
The correction widths of the jointed frames
must be the same value all the time. The
optimal joint cannot be achieved if the jointed
frames have different correction widths.
where the red line of one frame overlaps the
green line of the other frame.
The correction widths of the jointed frames
must be the same value all the time. The
optimal joint cannot be achieved if the jointed
frames have different correction widths.
The optimal point is where
these lines overlap.
Green line
Red line
Press
▲▼ to select “BRIGHT
9.
ADJUST”.
RIGHT
MARKER
MARKER
BRIGHT ADJUST
OFF
OFF
OFF