Panasonic TQBJ 0268-5 User Manual
76 –
ENGLISH
Projector setup (continued)
Installation Setting
A projection scheme can be chosen depending on
the installation of the projector. If the picture is shown
upside down or in reverse, change the projection
scheme.
the installation of the projector. If the picture is shown
upside down or in reverse, change the projection
scheme.
Select the setting by displaying the on-screen
•
indications using buttons of the remote control or
the control panel on the main unit.
the control panel on the main unit.
Press
▲▼ to select
1.
“INSTALLATION”.
PROJECTOR ID
INSTALLATION
ALTITUDE MODE
ALL
FRONT-FLOOR
ON
Press
◄► to switch
2.
“INSTALLATION”.
The setting will change as follows each time
•
◄► is pressed.
REAR-FLOOR
FRONT-CELING
REAR-CELING
FRONT-FLOOR
Floor mount front projection (FRONT-FLOOR)
Ceiling mount front projection (FRONT-CEILING)
Floor mount rear projection (REAR-FLOOR)
Ceiling mount rear projection (REAR-CEILING)
Press MENU twice.
3.
The on-screen indications disappear and the
•
normal screen appears again.
Altitude Mode
When using the projector over 1 400 m above sea
level, set to “ON”.
level, set to “ON”.
Press
▲▼ to select “ALTITUDE
1.
MODE”.
INSTALLATION
ALTITUDE MODE
DIRECTION
FRONT-FLOOR
ON
HORIZONTAL
Press
◄► to switch “ALTITUDE
2.
MODE”.
The setting will change as follows each time
•
◄► is pressed.
OFF
ON
Direction
The fan is controlled in accordance with the setup
angle.
angle.
Press
▲▼ to select
1.
“DIRECTION”.
ALTITUDE MODE
DIRECTION
LAMP SELECT
ON
HORIZONTAL
QUAD
Press
◄► to switch
2.
“DIRECTION”.
The setting will change as follows each time
•
◄► is pressed.
HORIZONTAL
VERTICAL
HORIZONTAL:
•
This is the standard setup.
VERTICAL:
•
Select this if the projector is tilted at a large vertical
angle (an angle which exceeds 30
angle (an angle which exceeds 30
°
from the
horizontal).