Panasonic TQBJ0349 User Manual

Powering ON/OFF

- ENGLISH

Basic Operation

Powering up the projector

Connect the supplied power cable.

1 )

(AC100-120 V 50-60 Hz)

Press the [ | ] marked side of the

2 )

MAIN POWER switch to turn on the

power.

The POWER indicator lamp on the projector will

flash in red. After a short period, the indicator will

illuminate and the projector will enter standby

mode.

Press POWER ON.

3 )

[Power indicator] lamp illuminates in green and

soon the image is projected on the screen.

Note

If the projector is powered up at about 0 °C, a warm-up

period of approximately 5 minutes may be necessary to

start projection. <TEMP> indicator lamp lights up during

the warm-up period. When the warm-up is completed,

<TEMP> indicator lamp turns off and the image is

projected on the screen.

If the temperature of the operating environment is low

and warm-up takes more than 5 minutes, the projector

will judge that a problem has occurred and the power

will be turned off automatically. If this happens, increase

the temperature around the projector so that it is 0 °C or

higher, and then turn on the MAIN POWER switch and

the POWER ON ( | ) switch once more.

With [ECO] setting in [Standby mode] (

page 64), When

switch on the projector, projection will start about 10

seconds late.

If the filter is not installed, the power is turned off

automatically after 10 minutes.

If projection was stopped last time by using the DIRECT

POWER OFF function, it can be started by setting the

MAIN POWER switch to the “ I ” (ON) position.

When you power up the projector or switch the signal

input, a high-frequency driving noise may be heard. This

is not a failure.

Making adjustment and

selection

It is recommended that the images are projected

continuously for at least 30 minutes before the focus

is adjusted.

Turn the focus ring, roughly adjust

4 )

the focus of the lens. (

page 34)

Select and set the projection scheme

5 )

of [INSTALLATION] and [COOLING

CONDITION] settings in [PROJECTOR

SETUP] menu.
Select the input signal by pressing

6 )

<INPUT SELECT> button (<RGB1>,

<RGB2>, <HDMI>, <VIDEO>,

<S-VIDEO>).
Adjust the tilt of the main unit in front

7 )

and rear or right and left.
Press <SHIFT> button to adjust the

8 )

position of the projection.
Press <AUTO SETUP> button if the

9 )

input signal is RGB signal.
Zoom the lens so the image fills the

10)

screen.
Readjust the focus.

11)

Readjust the zoom so that the image

12)

size fits in the screen.