Panasonic PT-DZ6700 User Manual

You can select a lamp lighting pattern for using environment. 
Press I H to cycle through options, and the ENTER button.

If using the projector for a continuous period of 24 hours or 
more, this setting can be used to automatically switch the 
lamps that are turned on in order to reduce the lamp 
deterioration that can occur as a result of continuous use.

(Not available for PT-D5000)
The luminance of the projection lamp can be changed 
depending on user’s needs or the viewing conditions.

You can select the electrical consumption while in standby 
mode.

This sets the communication parameters at the serial 
terminals.

You can customise the REMOTE 2 IN terminal function.

 

The pin assignment of the REMOTE 2 IN 
terminal is used as the projector default 
setting.

 

For changing an optional input module or 
customising the pin assignments.

All lamps will light.

Selects a lamp with shorter duration of 
use.

Selects the Lamp unit 1.

Selects the Lamp unit 2.

• If, in the SINGLE, LAMP1 or LAMP2 mode, one lamp remains 

off or the currently active lamp exceeds 2 000

*1

 hours of 

cumulative operating time (when HIGH is selected as the 
LAMP POWER setting

*2

), the other lamp will light. If, in the 

DUAL mode, one lamp remains off or the currently active lamp 
exceeds 2 000

*1

 hours of cumulative operating time (when 

HIGH is selected as the LAMP POWER setting

*2

), the other 

lamp alone will light. However, if both lamps remain off or the 
2 000

*1

 hours of cumulative operating time (when HIGH is 

selected as the LAMP POWER setting

*2

) are exceeded, the 

projector will enter the standby mode.

• The colours of the items indicate the status.

 

Green: Current setting

 

Yellow: Current setting (when a lamp fails or fails to light)

 

Red: Lamp that has failed to light

 

White: Any other status.

• If the projector is repeatedly used for short periods of time, the 

lamps will need to be replaced more frequently.

*1.  3 000 hours for PT-D5000 only.
*2.  Not available for PT-D5000.

Deactive

00:00 - 23:00

1 hour interval from 00:00 to 23:00

• Only when DUAL or SINGLE is selected in LAMP SELECT, 

LAMP RELAY is available. If LAMP1 or LAMP2 is selected, 
LAMP RELAY function is not available.

LAMP1 and LAMP2 light alternately by the 
set time, and the shorter duration of use 
lamp will light first.

After both lamps light for the set time, only 
one lamp is turned off for 2 hours, then for 
only the other lamp for next 2 hours. The 
longer duration of use lamp will be turned off 
first.

Set when high brightness is necessary.

Set when high brightness is not 
necessary.

• When set to LOW, it is possible to reduce power consumption, 

reduce operating noise and extend lamp service life.

• With ECO setting, NETWORK function, RS-232C output and 

some of RS-232C commands are not available. When switch 
on the projector, projection will start about 10 seconds late.

Select 9600, 19200 or 38400.

Select NONE, EVEN or ODD.

Select 9600, 19200 or 38400.

Select NONE, EVEN or ODD.

Select ON or OFF.

Select A to Z.

Select ON or OFF.

POWER H NONE

RGB1 H RGB2 H VIDEO H S-VIDEO H DVI-
D H BALLAST VERSION H REWIND ALL 
FILTER H NONE

SHUTTER H NONE

ENABLE H DISABLE