Panasonic PT-FW430U User Manual

Using Remote control

- ENGLISH

Preparation

Using Remote control

Installing and removing batteries

Open the cover

1 )

Install batteries and close the cover

2 )

(Insert the – side first.)

Remove the batteries in the reverse order of

installation.

Setting Remote control ID numbers

When you use the system with multiple projectors, you can operate all the projectors simultaneously or each

projector individually using single remote control, if unique ID number is assigned to each projector.

After setting the ID number of the projector, set the same ID number to the remote control.

The factory default of the projector’s ID number is [ALL]. When using single projector, use the <ID

ALL> button of the remote control. If you are not sure of the ID number of the projector, set the ID of the

projector to [ALL] pressing the <ID ALL> button of the remote control.

Setting the ID number

Press <ID SET> button, then input the projector’s ID number using numeric keys (<1> to <6>) within 5

seconds.

If the <ID ALL> button is pressed, you can operate the projectors regardless the setting of the projectors’ ID

numbers. (Simultaneous control mode)

Attention

Do not press <ID SET> button carelessly because the ID number on the remote control can be set even when no projector

is around. If you press <ID SET> and do not press the numeric key (<1> to <6>) within 5 seconds, the ID will remain the

same as before <ID SET> button was pressed.

Your specified ID number is stored in the remote control unless another one is specified later. However, the stored ID will

be erased if the batteries of the remote control are replaced or depleted. When the batteries are replaced, set the same ID

number again.

Note

For the setting of the projector’s ID number, see “PROJECTOR ID” of “PROJECTOR SETUP” (

page 56).