Manualsbrain.com
  1. Manuals
  2. Brands
  3. Panasonic
  4. PT-FW430U
  5. User Manual

Panasonic PT-FW430U User Manual

Download
Page of 89
56
 - ENGLISH
Settings
PROJECTOR SETUP menu
Select [PROJECTOR SETUP] from the Main 
Menu (see “Navigating through the menu” on 
page 35), then select the item from the sub-
menu.
After selecting the item, press ◄►▲▼ to set.
 
z
Remote Control
Control Panel
STATUS
Displays the status of the projector.
Press ▲▼ to select [STATUS].
1 ) 
Press the <ENTER> button.
2 ) 
The [STATUS] screen appears.
 
z
SIGNAL NAME Displays the input signal name.
SIGNAL  
FREQUENCY
Displays the frequency of the 
input signal.
PROJECTOR  
RUNTIME
Displays the projector runtime.
LAMP
Indicates the number of hours 
the lamp has been used
SERIAL  
NUMBER
Displays the serial number of the 
projector.
PROJECTOR ID
The projector has an ID number setting function that 
helps the user to control two or more projectors either 
simultaneously or separately with a single remote 
control.
Press ▲▼ to select [PROJECTOR ID].
1 ) 
Press the <ENTER> button.
2 ) 
The [PROJECTOR ID] screen appears.
 
z
Press ▲▼ to select [PROJECTOR ID].
3 ) 
Select [ALL] or a number between [1] and [6] 
 
z
from the list that appears.
ALL
1
6
2
Press the <ENTER> button to confirm 
4 ) 
the entry.
The selected [PROJECTOR ID] appears.
 
z
Note
If the projectors are given ID numbers, their remote 
 
z
controls must be assigned the same ID numbers, 
respectively.
If the ID number of a projector is set to [ALL], it can be 
 
z
controlled by the remote control or the PC with any ID 
number.
If multiple projectors are used and some of them 
have their IDs set to [ALL], they cannot be controlled 
separately from the projectors with other ID numbers. 
For details on remote control ID setting, refer to “Setting 
Remote control ID numbers” (
Æ
page 20).
INITIAL START UP
Use the steps below to select INITIAL START UP 
when the projector is connected to a wall outlet.
Press ▲▼ to select [INITIAL START 
1 ) 
UP].
Use ◄► to switch [INITIAL START UP] 
2 ) 
settings.
Each press of the button switches the settings 
 
z
as shown below.
LAST MEMORY
STANDBY
ON
LAST 
MEMORY
Starts up the projector in the mode it 
was in when last shut down
STANDBY
Starts up in standby mode
ON
Starts projection immediately