Panasonic PT-EW730Z User Manual

Chapter 1 Preparation — Start-up display

ENGLISH - 25

Initial setting (standby mode)

Set the operation mode during standby. The default setting is [ECO] that keeps power consumption low during standby. When the network

function is used during standby, set to [NORMAL]. After completed the initial setting, you can change the setting from the [PROJECTOR

SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE].

1) Press qw to switch the setting.

3/4

ENTER

SET

CHANGE

If STANDBY MODE is set to ECO, you cannot use

network functions when the projector is standing by.

Also, you cannot use some RS-232C protocol

commands.

STANDBY MODE

ECO

INITIAL SETTING

2) Press the <ENTER> button to proceed to the initial setting.

Note

The above initial setting screen is the one displayed when the projector is switched on for the first time after purchase. When [ALL USER

DATA] in the [PROJECTOR SETUP] menu → [INITIALIZE] is executed, the setting of [STANDBY MODE] before execution is displayed.

Initial setting (screen setting)

Set the screen format (aspect ratio) and display position of the image. After completed the initial setting, you can change the settings of each

item from the [DISPLAY OPTION] menu → [SCREEN SETTING].

1) Press as to select an item.
2) Press qw to switch the setting.

16:10

4/4

SCREEN POSITION
Set as necessary for the screen in use.

INITIAL SETTING

SET

CHANGE

MENU SELECT

SCREEN FORMAT

ENTER

3) Press the <ENTER> button.

Confirm the setting value and complete the initial setting.

Note

If you press the <MENU> button on the initial setting screen, you can go back to the previous screen.

To continue operations after completed the initial settings, refer to “Selecting the input signal” (x page 51).

By default, the time zone of the projector is set to +09:00 (Japan and Korean Standard Time). Change the setting in the [PROJECTOR

SETUP] menu → [DATE AND TIME] → [TIME ZONE] to the time zone of the region where you use the projector.