Panasonic PT-EX12KE User Manual

Check the external device connections (



 page 36) and power cord connections (



 page 41) and then turn on the 

power (



 page 43) to start projection. Select the input signal and adjust the image.

Select an input signal.

The images selected using the <INPUT> button on the control panel or the <INPUT 1> to <INPUT 4> buttons on 

the remote control are projected. (



 page 47)

■

z

Images may not be projected properly depending on the connected device, DVD, video tape, etc. to be played.

■

z

The <INPUT> button on the control panel cannot be used to select input signals. The input signal for each 

input terminal must be selected in advance using the [Input] menu. If you press the <INPUT> button without 

having correctly selected the input signal, the projector will not project the image correctly.

■

■Adjusting the position of the lens

■

z

[Lens shift] is displayed on the screen for four seconds.

Lens shift

2)  While the display appears, press ▲▼◀▶ to move the image horizontally and 

■

z

As you move the image, there is a certain position at which the arrows pointing up, down, left and right turn 

red. This position is the center for the lens.

■

z

At positions of maximum shift, the arrows disappear.

■

z

The projector stores the setting made using the lens shift function when the power is turned off.

■

z

When the position of the image is shifted, the image may become a little darker.

*  The figure below shows an example of when the standard lens is attached.

Moves the image up 

approx. 50% of its 

height.

Moves the image 

left approx. 10% of 

its width.

Moves the image 

right approx. 10% 

of its width.

Moves the image 

down approx. 50% of 

its height.