Manualsbrain.com
  1. Manuals
  2. Brands
  3. Panasonic
  4. PT-DW8300E
  5. User Manual

Panasonic PT-DW8300E User Manual

Download
Page of 129
POSITION menu
60
 - ENGLISH
Settings
Press ▲▼ to select [INTERLOCKED].
3 ) 
Press ◄► to switch [INTERLOCKED].
4 ) 
OFF
The [VERTICAL] and 
[HORIZONTAL] settings are used 
as the vertical and horizontal zoom 
ratios respectively.
ON
The zoom ratio is set to the [BOTH] 
setting.  
This allows the pictures to be 
zoomed at equal vertical and 
horizontal ratios.
Note
When [ASPECT] is set to [THROUGH], [ZOOM] will not 
 
z
appear.
When other than [DEFAULT] is selected for [ASPECT], 
 
z
the [MODE] selection setting will not appear.
CLOCK PHASE
Clock phase adjustment achieves the best image 
when the screen flickers or halos are observed around 
contours.
Press ▲▼ to select [CLOCK PHASE].
1 ) 
Press ◄► or <ENTER> button.
2 ) 
The [CLOCK PHASE] individual adjustment 
 
z
screen will be displayed.
Press ◄► to adjust the level.
3 ) 
The value changes from 0 to 63. Adjust so that 
 
z
the amount of interference is at a minimum.
Note
The CLOCK PHASE may not be adjusted, depending on 
 
z
the signal.
No optimal value may be obtained if the output of the PC 
 
z
to which the signal input is applied is unstable.
No optimal value may be obtained if the total number of 
 
z
dots is not correct.
The [CLOCK PHASE] can be adjusted only when RGB 
 
z
signal input is applied with RGB1 and RGB2 IN.
GEOMETRY  
(PT-DZ8700/PT-DS8500 only)
Square video can be projected onto a special shaped 
screen using unique image processing technology.
Press ▲▼ to select [GEOMETRY].
1 ) 
Press ◄► to switch [GEOMETRY].
2 ) 
The setting will change as follows each time 
 
z
◄► is pressed.
OFF
KEYSTONE
PC
CURVED
OFF
Geometry correction is not 
performed.
KEYSTONE This adjusts projected images when 
they are distorted to a trapezoid.
CURVED
This adjusts projected images 
when they are distorted to a curved 
surface.
PC 
Û
This is for performing geometry 
correction from a computer.
GEOMETRY adjustment should be carried out by 
: 
Û
a person who is familiar with the projector or by 
a service person because a high level of skill is 
required to make successful adjustment.
Select [KEYSTONE] or [CURVED] in 
3 ) 
Step 2), and press <ENTER> button.
The [GEOMETRY : KEYSTONE] or 
 
z
[GEOMETRY : CURVED] screen will be 
displayed.
Press ▲▼ to select the desired 
4 ) 
adjustment item, and press ◄► to 
adjust the correction amount.
You can adjust the projection images as shown 
 
z
below.