Panasonic PT-CX301RE User Manual

58

 - ENGLISH

If a problem should occur inside the projector, the <TEMP> and/or <LAMP>  indicators will inform you. Manage 

the indicated problems as follow.

Before you take a remedial measure, follow the procedure of switching the power off indicated in “Powering off the 

 

z

projector”. (

Æ

page 32)

Confirm the status of the power indicated on the <ON(G)/STANDBY(R)> indicator. (

 

z

Æ

page 31)

J

Lights in 

red

Temperature 

too high

Is the air intake/exhaust 

port blocked?

Remove any objects that are blocking the air intake/exhaust port.

Are the air filters 

blocked?

See air filters cleaning or replacing. (

Æ

pages 59-61)

Is the room 

temperature high?

Set up the projector in a location with an ambient temperature of 

5°C (41°F) ) to 40°C  (104°F)*.

Is the projector used 

above the altitude of  

1 000 m (3 300 ft) ? 

-  Use the projector between the altitude approx. 1 000 m  

(

3 300

 ft) and approx. 3 000 m (10 000 ft) and set [High Altitude] 

to [On]. (

Æ

page 48)

-  Do not use the projector at elevations approx. 3 000 m (10 000 ft).

Blinks in 

red

The fan has 

stopped

--

Disconnect the power plug from the power outlet and contact your 

dealer.

*  For the elevations below approx. 750 m (2 500 ft). When using the projector at the elevations between approx. 

750 m (2 500 ft) and approx. 1 500 m (5 000 ft) sea level, temperature will be 5°C (41°F)) to 35°C (95°F). When 

using the projector at the elevations between approx. 1 500 m (5 000 ft) and approx. 3 000 m (10 000 ft) sea 

level, temperature will be 5°C (41°F) to 30°C (86°F).

J

Lights in red

Lamp does not 

light; or lights out 

during projection

Does the projector be turned on 

immediately after powering off?

Turn on the projector until the lamp has 

completely cooled down.

Lamp unit failure; abnormal lamp 

power; lamp broken

Disconnect the power plug from the power 

outlet, and contact your dealer.

When re-start the projector, turn off the projector, unplug the power cord, and then wait 30 seconds or more before 

 

z

reconnecting power.

If the <TEMP> indicator lights or flashes or the <LAMP> indicator lights despite taking the actions above, plug out the AC 

 

z

power cord, and contact your dealer for repair.

<TEMP> indicator

<LAMP> indicator