Panasonic PT-EX12KU User Manual
Powering on/off
ENGLISH - 43
Basic Operation
Powering on the projector
Power
button
Power <POWER
ON> button
Control panel
Remote control
Before turning on the power, remove the lens cover.
1) Connect the power plug to the outlet.
(AC 100 V - 240 V 50 Hz/60 Hz)
2) Press the
side of the main power
switch to turn on the power.
■
z
After a moment, the standby indicator
<STANDBY> will go on and the projector will
enter the standby mode.
3) Press the power
button on the
control panel or the power <POWER
ON> button on the remote control.
■
z
After a moment, an image will be projected
and the currently selected input signal and
lamp status (
page 96) will be displayed for
approximately four seconds.
Note
■
z
When [PIN code lock] (
page 79) has been set to
[On] using [Security] in the [Setting] menu, enter
your PIN code.
■
z
The projector will make a noise when the lamp
comes on, but this is not a malfunction.
■
z
During projection, the fan rotates, making a sound.
The sound may change depending on the ambient
temperature, and when the lamp is on, the sound
may become loud.
■
z
If the lamp is switched off and immediately on
again, the newly projected image may wobble
for a few moments. This is due to the lamp
characteristics and is not a malfunction.
■
z
When [Direct on] (
page 78) of the [Setting] menu
is set to [On], the power will be turned on as soon
as you insert the power plug into the outlet or set
the main power switch to the side.
■
z
When [Display] (
page 69) of the [Setting] menu
is set to [On] and [Logo] (
page 76) is set to [Off],
the countdown will be displayed but the opening
display will not be displayed.
■
z
When [Display] (
page 69) of the [Setting] menu is
set to [Off] or [Countdown off], projection will start
as soon as the lamp comes on, regardless of [Logo
select] (
page 76) setting.
■
z
After turning on the power, notes on [Filter warning]
and [Lamp replacement] may be displayed
depending on the status of the projector. (
page 97)
Making adjustments and
selections
It is recommended that the images are projected
continuously for at least 30 minutes before the focus
is adjusted.
4) Press the <FOCUS> button to adjust
the focus of the image roughly.
(
page 46)
5) Press the <INPUT 1> to <INPUT 4>
buttons on the remote control or the
<INPUT> button on the control panel
to select the input terminal. (
page 47)
6) Adjust the projection angle. (
page 35)
■
z
Extend the adjustable feet to adjust the
projection angle.
7) Press the <LENS SHIFT> button to
adjust the position of the image.
(
page 45)
8) Press the <ZOOM> button to adjust
the size of the image to fit the screen.
(
page 46)
9) Press the <FOCUS> button again to
adjust the focus.
10) Press the <ZOOM> button again to
adjust the zoom and the size of the
image to fit the screen.