Panasonic PT-AE4000E User Manual

If a problem should occur with the projector, the 

LAMP and/or TEMP 

indicators will inform you. Manage the indicated problems as follows.

Confirm the status of all indicators and projector, and switch off 

1. 

the projector in proper way.

Find out the cause of the problem by status of the 

2. 

LAMP and/

or 

TEMP indicators.

Follow the following instruction for each indication and solve 

3. 

the problem.

Turn on the projector in the correct way and confirm the 

4. 

indicator is not indicating a problem any longer.

J

Illuminating red while projecting and the alert will be displayed.

 

 

Flashing red and the power button is turned off automatically.

 

 

When the 

 

 

TEMP indicator is lit, the lamp might have darkened. 

Adjustments can be performed but not all changes will be shown on the image.

The temperature inside and/or outside the projector is abnormally high.

The air intake and exhaust 

ports are covered.

The room temperature is 

too high.

The air filter is excessively 

dirty and the ventilation is 

poor.

The projector is located 

at high elevations (above 

1 400 - 2 700 m).

Remove the object(s) 

from the ventilation 

openings or clear around 

the projector.

Reinstall the projector in 

a temperature controlled 

place. See page 32.

Clean or replace the air 

filter in the proper method. 

See page 26.

Turn on the projector and 

set the 

MODE to ON.

See “INSTALLATION” of 

the functional instructions 

that is in the provided CD-

ROM.

J

Illuminating red

Flashing red

LAMP RUNTIME has 

reached 1 800 hours.

Lamp circuit failure, abnormal function or lamp unit is damaged.

The lamp unit will run out 

soon and needs to be 

replaced.

The power is turned on 

again before the lamp unit 

is cooled enough.

Lamp circuit failure, 

abnormal function.

The lamp unit is damaged.

See “Replacing the lamp 

unit” on page 27.

Let the lamp unit cool 

down and turn on the 

power after 90 seconds.

Contact an Authorised 

Service Centre.

See “Replacing the lamp 

unit” on page 27.

If no problem is found or the problem remains, do not turn on the projector. Instead contact an Authorised Service Centre.

 •