Pioneer PDSP-1 User Manual

 Check the recharge indicator in the upper right corner of the remote

control unit’s touch panel to confirm whether the remote control unit is
sitting on the recharger and recharging correctly.

 If the remote control unit’s battery won’t hold a sufficient charge to allow

use of the remote control unit even after proper recharging, the unit’s
Lithium-ion battery may require replacing. In this event, consult your
authorized Pioneer service center. The remote control unit’s Lithium-ion
battery cannot be purchased at any location other than an authorized
Pioneer service center.

 Check that the main power switch is turned on, the power cord is con-

nected securely, and the front panel’s POWER ON (Blue) or STANDBY
(Red) indicator is lighted.

 Check the remote control unit’s remaining charge indicator to confirm that

the remote control unit’s battery is properly recharged.

 You may be using the remote control too far from the sensor (Try moving

closer to the digital sound projector).

 Remote operation may become unreliable if direct sunlight, a fluorescent

lamp, or other strong light source is striking the remote control sensor on
the front panel.

 Depending on the model, some functions may not be supported.

 If the remote control menu screens do not change, try using the following

procedure to reset the remote control unit. Resetting the remote control
unit will not erase recorded settings.

 Disconnect the power plug from the outlet and insert again to return to

normal operating conditions.