Panasonic PT-FW300E User Manual

If the projector is aligned non-perpendicularly to the 
screen, or if the projection screen has an angled surface, 
you can correct keystone.

You can move the projected image for fine adjustment. 
Press I H to move horizontally and F G vertically. 
(Not available with NETWORK signals)

When H-FIT setting in ASPECT menu is selected, you 
can move the projected image vertically for fine 
adjustment by pressing I H. (Available with signals 
from NETWORK only)

If you have interference patterns of the projected image, 
which is sometimes referred to as moire or noise, you 
can minimize it by pressing I H to adjust the clock 
frequency. (Available with signals of RGB/DVI still only)

If you require further adjustment for the same reason as 
the DOT CLOCK adjustment, you can fine adjust the 
timing of the clock. Press I H to adjust. (Available with 
signals of RGB/DVI still only)

If the 4 edges of an image is partly dropped, you can use 
this function to adjust and project it properly. (Not 
available with signals of NETWORK)

 

I

Shrink

 

H

Enlarge

• You can correct the distortion ± 30 degrees from the 

plane. For a better quality image, installing the projector 
with a minimum of distortion is recommended.

• Some distortion may be retained for lens shift 

adjustment.

• The distortion of the main menu screen is not 

correctable.

• The result of the keystone correction will affect the 

aspect ratio and the size of the image.

 

 

SHIFT

H
V

• If the projecting signal’s dot clock frequency is higher 

than 150 MHz, the adjustment may not make a 
difference.

• DOT CLOCK needs to be adjusted before adjusting the 

CLOCK PHASE.

• If the projecting signal’s dot clock frequency is higher 

than 150 MHz, the adjustment may not make a 
difference.