Panasonic PT-AE3000E User Manual

When installing the projector, select the projection 
method according to the projector position. Press I H 
to cycle through the options. See “Projection method” on 
page 15.

You can select the required duration of time and set the 
off timer to turn off the power of the projector 
automatically. 3 minutes before turn-off, the countdown 
of minutes will be displayed in the lower right corner. 
Press I H to cycle through the options.

If you use the projector at high elevation, the HIGH 
ALTITUDE MODE setting need to be ON to set the fan 
speed high. Press I H to select the required option.

 

The fan speed is low.

 

The fan speed is high.

You can adjust the power of the lamp to save on 
electricity, prolong the lamp life and reduce the noise.

You can check how long the lamp has been used.

Setting on a desk/floor and 
projecting from front

Mounting on the ceiling and 
projecting from front

Setting on a desk/floor and 
projecting from rear

Mounting on the ceiling and 
projecting from rear

• At 1 400 - 2 700 m (4 593 - 8 858 ft) above sea level, 

the setting must be ON.

• The loudness of fan noise depends on the HIGH 

ALTITUDE MODE setting.

When higher luminance is 
required.

When lower luminance is 
sufficient.

• When no input signal is detected, the function is 

disabled.

• LAMP RUNTIME is a relevant matter for lamp 

replacement timing. See “Replacing the lamp unit” on 
page 47.