Panasonic PT-AE3000E User Manual

Do not touch the leaked liquid from the batteries.
 

If you touch the leaked liquid, it may hurt your skin. 
Immediately wash away the liquid with water and 
seek medical advice.

 

If you get the leaked liquid in your eye, it may cause 
blindness or damage. Never rub your eye, and 
immediately wash away the liquid with water and 
seek medical advice.

During a thunderstorm, do not touch the projector or 
the cable.
 

Electric shocks can result.

Do not use the projector in a bath or shower.
 

Fire or electric shocks can result.

Do not place your skin into the light beam while the 
projector is being used.
 

Strong light is emitted from the projector’s lens. If you 
place directly into this light, it can hurt or damage 
your skin.

Do not look into the lens while the projector is being 
used.
 

Strong light is emitted from the projector’s lens. If you 
look directly into this light, it can hurt and damage 
your eyes.

 

Be especially careful not to let young children look 
into the lens. In addition, turn off the power and 
disconnect the mains plug when you are away from 
the projector.

Do not place your hands or other objects close to the 
air exhaust port.
 

Heated air comes out of the air exhaust port. Do not 
place your hands or face, or objects which cannot 
withstand heat close to this port [allow at least 
50 cm (20") of space], otherwise burns or damage 
could result.

Replacement of the lamp is recommended to be 
carried out by a qualified technician.
 

The lamp has high internal pressure. If improperly 
handled, explosion might result.

 

The lamp can easily become damaged if struck 
against hard objects or dropped, and injury or 
malfunctions may result.

When replacing the lamp, allow it to cool for at least 
one hour before handling it.
 

The lamp cover gets very hot, and touching it can 
cause burns.

Before replacing the lamp, be sure to disconnect the 
mains plug from the mains socket.
 

Electric shocks or explosions can result if this is not 
done.

Do not allow infants or pets to touch the remote 
control unit.
 

Keep the remote control unit out of the reach of 
infants and pets after using it.

Do not cover the air intake port or the air exhaust 
port.
 

Doing so may cause the projector to overheat, which 
can cause fire or damage to the projector.

 

Do not place the projector in narrow, badly ventilated 
places such as closets or bookshelves.

 

Do not place the projector on cloth or papers, as 
these materials could be drawn into the air intake 
port.

Do not set up the projector in humid or dusty places 
or in places where the projector may come into 
contact with oily smoke or steam.
 

Using the projector under such conditions may result 
in fire, electric shocks or plastic deterioration. The 
plastic deterioration may cause the falling down of 
the projector which is mounted on the ceiling.

Do not set up the projector in a high temperature 
environment, such as near a heater or in direct 
sunlight.
 

Failure to observe this may result in fire, malfunction 
or plastic deterioration.

Do not set up the projector outdoors.
 

The projector is designed for indoor use only.

When disconnecting the mains lead, hold the plug, 
not the lead.
 

If the mains lead itself is pulled, the lead will become 
damaged, and fire, short-circuits or serious electric 
shocks may result.

Always disconnect all cables before moving the 
projector.
 

Moving the projector with cables still attached can 
damage the cables, which could cause fire or electric 
shocks to occur.

Do not place any heavy objects on top of the 
projector.
 

Failure to observe this may cause the projector to 
become unbalanced and fall, which could result in 
damage or injury.