Panasonic PT-AE2000U User Manual

The serial connector which is on the connector panel of the projector conforms to the RS-232C interface 
specification, so that the projector can be controlled by a personal computer which is connected to this connecter.

J

J

J

(When connected to a personal computer)

J

 

The projector can not receive any command for 10 seconds after the lamp is switched on. Wait 10 seconds 
before sending the command.

 

If sending multiple commands, check that a response has been received from the projector for one 
command before sending the next command.

 

When a command which does not require parameters to be sent, the colon (:) is not required.

 

If an incorrect command is sent from the personal computer, the ER401 command will be sent from the 
projector to the personal computer.

• You must use only an RS-232C Serial Interface Cable with a ferrite core, type ET-ADSER.

A

NC

B

TXD

Transmitted data

C

RXD

Received data

D

NC

E

GND

Earth

F

NC

G

RTS

Connected internally

H

CTS

I

NC

The data streaming from the computer will 
start with STX, and proceed to Command, 
Parameter and end with ETX. You can 
add the required parameter.

NC

NC

NC

NC

NC

NC

NC

NC

Start byte

(02h)

1 byte

End

(03h)

3 bytes

1 byte - 

4 bytes