Panasonic PT-VW430U User Manual

If a problem should occur inside the projector, the <ON(G)/STANDBY(R)>, <LAMP> and/or <WARNING> 

indicators will inform you. Manage the indicated problems as follow.

Before you take a remedial measure, follow the procedure of switching the power off indicated in “Turning off the projector”. 

 

z

(

Æ

page 30)

If multiple indicators light or blink, verify the status of the projector by looking at each indicator.

 

z

Confirm the status of the power indicated on the <ON(G)/STANDBY(R)> indicator.

 

z

J

Lighting in yellow

The projection lamp reaches its end of life.

Is there a Lamp replacement icon appears on the screen?

Replace the lamp unit.  

(

Æ

page 81)

Contact your dealer for repair services when <LAMP> indicator persists to light after taking these measurements.

 

z

J

Lights in red.

Blinks in red.

The projector detects an abnormal 

condition and cannot be turned 

on. 

If the temperature within the projector becomes too high, 

the <WARNING> indicator will start to flash slowly.  

If the temperature within the projector becomes even 

higher, the <WARNING> indicator will flash faster, and the 

<ON(G)/STANDBY(R)> indicator blinks in orange.  When 

the projector has cooled inside and returned to operating 

temperature, it will turn off automatically.

Unplug the AC power cord 

and plug it again to turn on the 

projector. 

-  Did you provide appropriate space for the projector to be   

ventilated? Check the installing condition to see if the air  

vents of the projector are not blocked.

- Has the projector been installed near an Air-

  Conditioning/ Heating Duct or Vent? 

- Are the filters clean? 

If the projector is turned off again, 

unplug the AC power cord and 

contact the dealer or the service 

center for service and checkup. 

- Provide good installing condition to your projector.

- Move the installation of the projector away from the duct    

  or vent.

- Replace filters.

If <WARNING> indicator persists to light or blink after taking these measurements, please contact your dealer for repair 

 

z

services. Do not leave the projector on. It may cause an electric shock or a fire hazard.

The projector detects an abnormal condition and cannot be turned on. Unplug the AC power cord and plug it again to turn 

 

z

on the projector. If the projector is turned off again, unplug the AC power cord and contact the dealer or the service center 

for service and checkup. Do not leave the projector on. It may cause an electric shock or a fire hazard.