Panasonic PT-VX505NE User Manual

-72-

Each indicator on the projector indicates the operating status of the projector. If you find the un-expected operation 

during usage, check the projector's operation with the tables below. The indicators also let you know the maintenance 

sign. To use the projector in the best performance for a long period of time, take an adequate maintenance according 

to the indicator status.

Lighting in yellow

The projection lamp reaches its end of life.

Is there a Lamp replacement icon appears on the screen?

Replace the lamp unit.

Lights in red.

Blinks in red.

The projector detects an abnormal 

condition and cannot be turned on.

If the temperature within the projector becomes too 

high, the <WARNING> indicator will start to flash 

slowly.  

If the temperature within the projector becomes even 

higher, the <WARNING> indicator will flash faster, 

and the <ON(G)/STANDBY(R)> indicator blinks in 

orange.  When the projector has cooled inside and 

returned to operating temperature, it will turn off 

automatically. 

Unplug the AC power cord and plug 

it again to turn on the projector.

-  Did you provide appropriate space for the projector 

to be   ventilated? Check the installing condition to 

see if the air  vents of the projector are not blocked.

- Has the projector been installed near an Air-

  Conditioning/ Heating Duct or Vent? 

- Are the filters clean? 

If the projector is turned off again, 

unplug the AC power cord and 

contact the dealer or the service 

center for service and checkup. 

- Provide good installing condition to your projector.

- Move the installation of the projector away from the 

duct or vent.

- Replace filters.

No illumination or flashing

The power cord is unplugged.

The power cord is plugged

The projector is in stand-by mode, after the cooling is completed.

The projector is cooling down. The projector cannot be turned on until cooling is 

completed and the <ON(G)/STANDBY(R)> indicator stops blinking.

The temperature inside the projector is abnormally high. And the <WARNING> 

indicator also blinks in red. The projector cannot be turned on until cooling is 

completed and the <ON(G)/STANDBY(R)> indicator stops blinking.

Projecting.

The projector is in stand-by status with [Power management] function.

The projection lamp will be turned on if the input signal is reconnected or any 

button on the control panel or remote control is pressed.

:

-If <WARNING> indicator persists to light or blink after taking these measurements, please contact your dealer for repair ser-

vices. Do not leave the projector on. It may cause an electric shock or a fire hazard.

-  The projector detects an abnormal condition and cannot be turned on. Unplug the AC power cord and plug it again to turn on 

the projector. If the projector is turned off again, unplug the AC power cord and contact the dealer or the service center for ser-

vice and checkup. Do not leave the projector on. It may cause an electric shock or a fire hazard.