Panasonic PT-RW330U User Manual
Chapter 1 Preparation — Precautions for use
14 - ENGLISH
Precautions for use
Cautions when transporting
f
When transporting the projector, hold it securely by its bottom and avoid excessive vibration and impacts. Doing so may
damage the internal components and result in malfunctions.
f
Do not transport the projector with the adjustable feet extended. Doing so may damage the adjustable feet.
Cautions when installing
r
Do not set up the projector outdoors.
The projector is designed for indoor use only.
r
Do not set up the projector in the following locations.
f
Places where vibration and impacts occur such as in a car or vehicle: Doing so may cause damage to internal components
or malfunction.
f
Near the exhaust of an air conditioner: Depending on the conditions of use, the screen may fluctuate in rare cases due
to the hot air from the air exhaust port or the heated or cooled air. Make sure that the exhaust from the projector or other
equipment, or the air from the air conditioner does not blow toward the front of the projector.
f
Near lights (studio lamps, etc.) and other locations with severe temperature fluctuations (“Operating environment”
(x page 124)): Placing the projector in these locations may result in malfunctions and the deformation of the outer case.
f
Near high-voltage power lines or near motors: Doing so may interfere with the operation of the projector.
f
Place where there is high-power laser equipment: Directing a laser beam onto the lens surface causes damage to the DLP
chips.
r
Be sure to ask a specialized technician or your dealer when installing the product to a
ceiling.
The optional ceiling mount bracket is required.
Model No.: ET-PKR100H (for high ceilings), ET-PKR100S (for low ceilings)
Model No.: ET-PKR100H (for high ceilings), ET-PKR100S (for low ceilings)
r
Ask a qualified technician or your dealer to install the cable wiring for DIGITAL LINK
connection.
Image and sound may be disrupted if cable transmission characteristics can not be obtained due to inadequate installation.
r
The projector may not work properly due to strong radiowave from the broadcast
station or the radio.
If there is any facility or equipment, which outputs strong radiowave, near the installation location, install the projector at a
location sufficiently far from the source of the radiowave. Or, wrap the LAN cable connected to the <DIGITAL LINK/LAN>
terminal by using a piece of metal foil or a metal pipe, of which is grounded at both ends.
r
Lens focus
The high clarity projection lens is thermally affected by the light from the light source, making the focus unstable in the period
just after switching on the power. Wait at least 30 minutes with the image projected before adjusting the lens focus.
r
Do not install the projector at elevations of 2 700 m (8 858') or higher above sea level.
Doing so may shorten the life of the internal components and result in malfunctions.
r
Do not use the projector tilted to the right or left.
Using the projector at a vertical angle that exceeds 15° may reduce product life or result in malfunction.
r
When installing and using the projector at an angle that exceeds 30° vertically, set
[COOLING CONDITION] (x page 70).
Failure to observe this will result in malfunctions or shorten the life of the internal components.