Panasonic PT-RW330U User Manual
Chapter 2 Getting Started — Connecting
28 - ENGLISH
<HDMI IN> terminal pin assignments and signal names
Outside view
Pin No.
Signal name
Pin No.
Signal name
Even-numbered pins
(2) to (18)
(1)
(19)
(2)
(18)
Odd-numbered pins
(1) to (19)
(1)
T.M.D.S data 2+
(11)
T.M.D.S clock shield
(2)
T.M.D.S data 2 shield
(12)
T.M.D.S clock-
(3)
T.M.D.S data 2-
(13)
CEC
(4)
T.M.D.S data 1+
(14)
—
(5)
T.M.D.S data 1 shield
(15)
SCL
(6)
T.M.D.S data 1-
(16)
SDA
(7)
T.M.D.S data 0+
(17)
DDC/CEC
GND
(8)
T.M.D.S data 0 shield
(18)
+5 V
(9)
T.M.D.S data 0-
(19)
Hot plug detection
(10)
T.M.D.S clock+
Connecting example: AV equipment
'9'SOD\HUZLWK+'0,
WHUPLQDO+'&3
9&5ZLWKEXLOWLQ7%&
%OXUD\GLVFSOD\HU
$XGLRGHYLFH
Attention
f
Always use one of the following when connecting a VCR.
g
A VCR with built-in time base corrector (TBC)
g
A time base corrector (TBC) between the projector and the VCR
f
If nonstandard burst signals are connected, the image may be distorted. In such case, connect the time base corrector (TBC) between the
projector.
f
Use a commercial HDMI/DVI conversion cable with a ferrite core.
Note
f
The <DVI-I IN> terminal can be connected to HDMI- or DVI-I-compliant devices. However, images may not appear or may not be displayed
properly on some devices. (x page 62)
f
For an HDMI cable, use an HDMI High Speed cable that conforms to HDMI standards. If a cable that does not conform to HDMI standards
is used, images may be interrupted or not displayed, or the projector may not function properly.
f
The <HDMI IN> terminal of the projector can be connected to an external device with an DVI terminal by using an HDMI/DVI conversion
cable, but some devices may not project the image properly or function properly. (x page 63)
f
When DVI-I is input, some external devices to be connected may require EDID to be set. (x page 62)
f
The projector does not support VIERA Link (HDMI).
f
If the [AUDIO IN SELECT] settings are incorrect, the projector may not output audio or otherwise function properly. (x page 78)