Panasonic PT-RW330U User Manual
Chapter 4 Settings — [PICTURE] menu
50 - ENGLISH
[SYSTEM SELECTOR]
The projector will automatically detect the input signal, but you can set the system method manually when an unstable signal is input. Set the
system method matching the input signal.
1)
Press as to select [SYSTEM SELECTOR].
2)
Press the <ENTER> button.
3)
Press as to select a system format.
f
Available system formats vary depending on the input signal.
Terminal
System format
<VIDEO IN> terminal
Select [AUTO], [NTSC], [NTSC4.43], [PAL], [PAL-M], [PAL-N], [SECAM], or [PAL60].
Set it to [AUTO] normally. (The [AUTO] setting will automatically select [NTSC], [NTSC4.43], [PAL],
[PAL-M], [PAL-N], [SECAM], or [PAL60].)
Switch the setting to the signal method for the TV used.
<COMPUTER IN> terminal,
<DVI-I IN> terminal
*1
480i, 576i, or 576p signal
Select [RGB] or [YC
B
C
R
].
VGA60 or 480p signal
Select [VGA60], [480p], or [480pRGB].
Other movie based signals
Select [RGB] or [YP
B
P
R
].
<DVI-I IN> terminal
*2
480p or 576p signal
Select [RGB], [YC
B
C
R
444], or [YC
B
C
R
422].
Other movie based signals
Select [RGB], [YP
B
P
R
444], or [YP
B
P
R
422].
<HDMI IN> terminal
480p or 576p signal
Select [AUTO], [RGB], [YC
B
C
R
444], or [YC
B
C
R
422].
Other movie based signals
Select [AUTO], [RGB], [YP
B
P
R
444], or [YP
B
P
R
422].
*1 When [DVI-I IN] is set to [ANALOG].
*2 When [DVI-I IN] is set to [DIGITAL].
4)
Press the <ENTER> button.
Note
f
Refer to “List of compatible signals” (x page 121) for compatible signals.
f
This may not function properly for some external devices that are connected.
sRGB-compliant video
sRGB is an international standard (IEC61966-2-1) for color reproduction defined by IEC (International Electrotechnical Commission).
Set the projector using the following procedures for more accurate color reproduction that complies with sRGB.
Set the projector using the following procedures for more accurate color reproduction that complies with sRGB.
1)
Set [COLOR MATCHING] adjustments to [OFF].
f
Refer to [COLOR MATCHING] (x page 59).
2)
Display the [PICTURE] menu.
f
Refer to “[PICTURE] menu” (x page 46).
3)
Press as to select [PICTURE MODE].
4)
Press qw to set [NATURAL].
5)
Press as to select [COLOR].
6)
Press the <DEFAULT> button on the remote control to set factory default settings.
7)
Follow Steps 5) to 6) to set factory default settings for [TINT] and [COLOR TEMPERATURE].
Note
f
sRGB is available for RGB signal input only.