Panasonic PT-RW330U User Manual
Chapter 4 Settings — [PROJECTOR SETUP] menu
72 - ENGLISH
4)
Press qw to switch [STANDBY MODE].
f
The items will switch each time you press the button.
[ECO]
Use this setting to reduce power consumption during standby.
[NORMAL]
Use this setting to use the network function during standby.
Note
f
When set to [ECO], network functions are not available during standby. Also, some RS-232C commands are not available. When set to
[NORMAL], network functions are available during standby.
f
If set to [ECO], there may be a delay in displaying when the power is turned on compared to when set to [NORMAL].
Setting [ECO LEVEL DISPLAY]
Display the power save level by the settings of [LIGHT POWER] and [AUTO POWER SAVE] as an illustration at the left bottom of the
projection screen.
The more the number of green Leaf mark (
The more the number of green Leaf mark (
), the more the power of the projector is saved.
Screen display example:
(&2/(9(/
1)
Press as to select [ECO MANAGEMENT].
2)
Press the <ENTER> button.
f
The
[ECO MANAGEMENT] screen is displayed.
3)
Press as to select [ECO LEVEL DISPLAY].
4)
Press qw to switch [ECO LEVEL DISPLAY].
f
The items will switch each time you press the button.
[OFF]
Disables the ECO level display.
[ON]
Enables the ECO level display.
Note
f
If a closed caption signal of the selected mode is input, the ECO level is not displayed.
f
The ECO level is not displayed when the menu screen is displayed.
[SCHEDULE]
Set the command execution schedule for each day of the week.
Enabling/disabling the schedule function
1)
Press as to select [SCHEDULE].
2)
Press qw to switch [SCHEDULE].
f
The items will switch each time you press the button.
[OFF]
Disables the schedule function.
[ON]
Enables the schedule function. Refer to “How to assign a program” (x page 72) or “How to set a
program” (x page 73) for how to set the schedule.
Note
f
When [SCHEDULE] is set to [ON], the [STANDBY MODE] setting is forcibly switched to [NORMAL], and the setting cannot be changed.
Even if [SCHEDULE] is then set to [OFF] when in this state, the setting of [STANDBY MODE] remains at [NORMAL].
How to assign a program
1)
Press as to select [SCHEDULE].
2)
Press qw to select [ON], and press the <ENTER> button.
f
The
[SCHEDULE] screen is displayed.