Panasonic PTVX410ZU User Manual
Attaching the air filter unit
Attach the unused air filter unit to the projector.
1)
Hold the air filter unit that the tab is in up-left side in the figure, put the right side in the figure first, and press the tab side
f
until make a click sound.
Do not press any other part of the air filter unit except the frame during installation.
f
Install the air filter cover.
2)
Perform Step 1) in “Removing the air filter unit” (
f
Æ
page 95) in the reverse order .
Make sure that the air filter cover is closed tightly.
f
Resetting the filter counter.
Be sure to reset the filter counter after replacing the air filter unit.
Connect the power plug, press the <
1)
v
/b> button on the control panel or on the remote control.
Press the <MENU> button to display the main menu, then press
2)
as
to select [PROJECTOR SETUP].
Press the <ENTER> button, press
3)
as
to select [FILTER COUNTER].
Press the <ENTER> button, press
4)
as
to select [FILTER COUNTER RESET].
Press the <ENTER> button.
5)
[FILTER COUNTER RESET] confirmation is displayed.
f
Press
6)
qw
to select [OK], then press the <ENTER> button.
The filter usage time is 0 after reset.
f
Attention
Turn off the power before you replace the air filter unit.
f
When attaching the air filter unit, make sure that the projector is stable, and work in an environment that is safe, even in the
f
event of the air filter unit dropping.
Make sure that the air filter unit is properly attached before using the projector. If it is not attached, the projector will suck in
f
dirt and dust causing a malfunction.
Do not put anything into the air vents. Doing so may result in malfunction of the projector.
f
The air filter unit to be replaced should be an unused product.
f
After replacing the air filter, reset the filter counter. Otherwise, “FILTER COUNTER has reached the set time.” will appear on
f
screen.
Note
The replacement cycle of the air filter unit varies greatly depending on the usage environment.
f
Lamp unit
The lamp unit is a consumable component.
It is recommended to ask an authorized engineer to replace the lamp unit. Contact your dealer.
Consult your dealer to purchase a replacement lamp unit (ET-LAV300).
Warning
Do not replace the lamp unit when it is hot. (Wait at least 1 hour after use.)
The inside of the cover can become very hot, take care to avoid burn injuries.
Tab
96 - ENGLISH
Chapter 5 Maintenance - Replacement