NEC NP510WSG User Guide
6
1. Introduction
AC Input
Connect the supplied power cable’s two-pin plug here, and
plug the other end into an active wall outlet. (
Connect the supplied power cable’s two-pin plug here, and
plug the other end into an active wall outlet. (
→ page
Main Power Switch
When you plug the supplied power cable into an active wall outlet
and turn on the Main Power, the POWER indicator turns orange
and the projector is in standby mode.
(
When you plug the supplied power cable into an active wall outlet
and turn on the Main Power, the POWER indicator turns orange
and the projector is in standby mode.
(
→ page
)
Terminal Panel (
→ page
Monaural Speaker (7W)
Ventilation (outlet)
Heated air is exhausted from here.
Heated air is exhausted from here.
Ventilation (inlet) / Filter Cover
(
→ page
Lamp Cover (
→ page
)
Rear Foot (
→ page
)
Spacer (black rubber)
To fine-adjust the height of the rear foot,
remove the spacer and rotate the rear
foot to the desired height.
To fine-adjust the height of the rear foot,
remove the spacer and rotate the rear
foot to the desired height.
Rear