Princeton 4300 User Manual
Chapter 7
Troubleshooting
67
67
To change the default Camera Name:
1. Using Notepad or a similar text editor, open PVCAM.INI, which is located in
the Windows directory (C:\Windows, for example). You should see entries like
the ones below.
[Camera_1]
[Camera_1]
Type=1
Name=Camera1
Name=Camera1
Driver=apausb.sys
Port=0
ID=523459
2. Change the "Name=" entry to something more meaningful for you (for example,
ST133USB - to indicate that this is a PVCAM-based system using an ST-133
with a USB 2.0 interface) and save the edited file.
[Camera_1]
[Camera_1]
Type=1
Name=ST133USB
Name=ST133USB
Driver=apausb.sys
Port=0
ID=523459
3. The new camera name will now appear in the
Camera Name
field.
Changing the ST-133's Line Voltage and Fuses
The appropriate voltage setting for your country is set at the factory and can be seen on
the power input module. If your voltage source changes, you will need to change the
voltage setting and you may need to change the fuse configuration.
Use proper fuse values and types for the controller and camera to be properly protected.
To Change Voltage and Fuse Configuration:
Turn the Controller OFF and unplug the line cord before opening the power
input module.
1. As shown in Figure 32, place the flat
side of a flat bladed screwdriver
parallel to the back of the Controller
and behind the small tab at the top of
the power module, and twist the
screwdriver slowly but firmly to pop
the module open.
Figure 32. Power Input Module
2. To change the voltage setting, roll the
selector drum until the setting that is
closest to the actual line voltage is
facing outwards.
WARNING!
WARNING!