Compaq 243850-002 User Manual

Ä

CAUTION: To prevent loss of work and damage to the computer or drive:

■

If you are inserting or removing a hard drive, shut down the 
operating system properly, then turn off the computer. Do not 
remove a hard drive while the computer is on or in standby mode.

■

Before handling a drive, ensure that you are discharged of static 
electricity. While handling a drive, avoid touching the connector. For 
more information about preventing electrostatic damage, refer to 
Appendix E, "Electrostatic Discharge."

■

Handle a drive carefully, do not drop it.

■

Do not use excessive force when inserting a drive.

■

Avoid exposing a hard drive to liquids, temperature extremes, or 
products that have magnetic fields such as monitors or speakers.

le: 

1. Shut down the operating system properly, then turn off the 

computer and any external devices, disconnect the power cord 
from the power outlet, and remove the computer cover.

2. Remove the front bezel. See “Removing the Front Bezel.”

3. Install four guide screws, two guide screws on each side of the 

drive.

✎

Some options use metric hardware. Extra guide screws are provided 
on the front of the chassis, under the front bezel. The 
Compaq-supplied metric screws are black.

4. Install the drive in the desired drive bay by sliding it into the front 

of the drive cage; the drivelock automatically secures the drive in 
the bay.

✎

Be sure the guide screws line up with the guide slots in the drive cage.

5. If it is a CD-ROM or DVD-ROM drive and if analog audio is 

preferred to digital audio, connect the audio cable 1. The other 
end of the audio cable 1 should be connected to the embedded 
audio connector on the system board. 

6. Connect the signal 2 and drive power 3 cables.