The Siemon Company S210 Leaflet

Mount the S210

™

wiring base

and legs onto a suitable mounting
surface with the necessary screws
and hardware.

Remove the S210 wiring
base from the legs by

depressing the outer 4 fanning strips
of the S210 wiring base inward to
defeat the leg latches. Pull the
wiring base away from the legs.

Note: Legs are detachable on the
64-pair version only.

Mount S210 19 inch panel

onto the rack using the #12-24
screws and washers provided.

Lace the cables through the
appropriate openings in the

S210 base. Proceed to step 9 for ter-
minating instructions.

With the S210 base
removed, route the cable

between the legs.

Lace the cables through the
appropriate openings in the

wiring base and snap the S210 wiring
base back onto the legs. Push the
wiring base onto the legs until the
latches “snap” into place. Proceed to
step 9 for terminating instructions.

Note: For additional security, the assembly
can be fastened together using the self-
tapping, Phillips-head screws included.

Strip back only as much cable

jacket as is necessary to terminate
the conductors using the Siemon
AllPrep

™

Cable Preparation Tool

(P/N: CPT-RGTP) or equivalent.

Note: It is not recommended to strip
more than 76mm (3 in.) of cable jacket for
category 5 or higher installations.

Lace the conductors into the
S210 wiring base. Pair twist

must be maintained to within 12mm
(.5 in.) of the point of termination for
category 5 or higher installations.
Ample channel space is provided to
allow jacketed cable to continue
close to the point of termination.

Note: The Pyramid

™

wire entry system on the

base and block will separate twisted conduc-
tors without special preparations or handling.

Mount S89B or S89D bracket onto a
suitable mounting surface with the
necessary screws and hardware.
Route the cable through the center
channel of the bracket.

Lace the cables through the
center hole of the S210

™

89

retainer and snap the retainer onto
the S89 bracket. Proceed to step 9
for terminating instructions.