Cabletron Systems TRXI-24 User Manual
INSTALLATION
Page 3-13
3.8.2
Installing a TPIM to the TRXI
To install a TPIM, perform the following steps:
Caution: Observe all static precautions while handling TPIMs.
1.
Remove the mounting screw from the faceplate of the RI/RO port
on the TRXI.
on the TRXI.
2.
If you are replacing a TPIM, remove the mounting screw and pull
the TPIM straight out from the TRXI.
the TPIM straight out from the TRXI.
3.
Slide the new TPIM into place as shown in Figure 3-12.
4.
Ensure the connectors on the rear of the module and on the inside
of the TRXI mate properly.
of the TRXI mate properly.
5.
Reinstall the mounting screw.
Figure 3-12. Installing a TPIM
RI
RO
6
5
4
3
2
1
18
17
16
15
14
13
TPIM-T1
LNK
TPIM-T1
LNK