Cabletron Systems TRFMIM-28 User Manual

 

2-5

Installing the 9H423-28 Module

 

To install the 9H423-28 module in the SmartSwitch 9000 chassis, follow the steps 
below:

1. Remove the blank panel covering the slot in which the module will be 

mounted. All other slots must be covered to ensure proper air flow and 
cooling.

2. Attach one end of the ESD wrist strap (packaged with the SmartSwitch 9000 

chassis) to your wrist. Plug the other end into the jack for the ESD Wrist Strap 
in the lower right corner of the SmartSwitch 9000 chassis shown in Figure 2-3. 

3. Install the module in the chassis by sliding it into slots and locking down both 

the top and bottom plastic tabs, as shown in Figure 2-3. Take care that the 
module is between the card guides as shown, it slides in straight, and engages 
the backplane connectors properly.