ICP DAS USA MSM-6226 User Manual
reinitializing LLDP transmission. (Default: 2 secs)
Notification
Interval: The minimum interval for LLDP data change Notification fpr the
Interval: The minimum interval for LLDP data change Notification fpr the
same neighbor. Refer to IEEE 802.1AB-2005 or later for more
information. (Default: 5 secs)
information. (Default: 5 secs)
Mode : To enable or disable the LLDP mode per port. There are four
type includes Disable, Tx_Rx, Tx only and Rx only
Port Descr : To evoke the outbound LLDP advertisements, includes an
alphanumeric string describing the port.
Sys Name : To evoke the outbound LLDP advertisements, includes the
system’s assigned name
Sys Descr : To evoke outbound LLDP advertisements, includes an
alphanumeric string describing the full name and version
identification for the system’s hardware type, software version,
and networking application.
identification for the system’s hardware type, software version,
and networking application.
Sys Capa : To evoke outbound advertisements, includes a bitmask of
system capabilities (device functions) that are supported. Also
includes information on whether the capabilities are enabled.
includes information on whether the capabilities are enabled.
Mgmt Addr : To evoke outbound advertisements, includes information on
management address. you can use to include a specific IP
address in the outbound LLDP advertisements for specific ports
address in the outbound LLDP advertisements for specific ports
Notification : Default: Disabled.
Enables or disables each port for sending notification to
configured SNMP trap receiver if an LLDP data change is
detected in an advertisement received on the port from LLDP
neighbor.
configured SNMP trap receiver if an LLDP data change is
detected in an advertisement received on the port from LLDP
neighbor.