Cabletron Systems BRIM-A6 User Manual

Chapter 2: Installation

5. Remove the faceplate mounting screws and the BRIM coverplate. 

6. Remove the standoff screws. See Figure 2-2.

7. Place the BRIM behind the hub faceplate. See Figure 2-3.

8. Insert the connector pins of the BRIM-A6 into the BRIM connector on 

the hub.

9. Press down firmly on the back of the BRIM-A6 until the pins slide all 

the way into the connector holes.

10. Reinstall the faceplate mounting screws and the standoff screws.

11. Reattach the chassis cover to the hub, reconnect the power cord, and 

reconnect the hub to your network.

12. Refer to Chapter 3 for instructions on configuring the BRIM-A6 using 

Local Management.

Ensure that the standoffs on the hub align with the standoff 
screw holes on the BRIM.

Ensure that the chassis cover is in place before reconnecting 
the power cord.

book  Page 6  Thursday, April 18, 1996  2:18 PM