Cabletron Systems CSX1000 User Manual
USER’S GUIDE
310 CyberSWITCH
correct network/range and begins using the learned network number/range. If the network
number/range configured for the Remote LAN port differs from the network number/range that
is being broadcasted in RTMP packets by other remote routers, the port becomes unusable.
number/range configured for the Remote LAN port differs from the network number/range that
is being broadcasted in RTMP packets by other remote routers, the port becomes unusable.
Configuration
In order to properly set up an AppleTalk Remote LAN, you must:
•
•
enable AppleTalk Routing from Options
•
configure the WAN (Remote LAN)
from Options, AppleTalk Routing, AppleTalk Ports
•
and optionally specify an AppleTalk network number for the pertinent device
level entries from Security, Device-Level Databases, On-node Device Entries
Considerations
Note the following in regard to the AppleTalk Remote LAN feature:
•
•
The CyberSWITCH does not initiate connections to AppleTalk Remote LAN devices. The re-
mote bridge is responsible for connecting to the CyberSWITCH. The CyberSWITCH can for-
ward packets to the remote device once a connection is established.
mote bridge is responsible for connecting to the CyberSWITCH. The CyberSWITCH can for-
ward packets to the remote device once a connection is established.
•
AppleTalk spoofing is not currently supported for this feature.
•
Off-node route lookup is not currently supported for this feature.
A
PPLE
T
ALK
S
TATIC
R
OUTES
C
ONFIGURING
A
PPLE
T
ALK
S
TATIC
R
OUTES
U
SING
CFGEDIT
1.
Select AppleTalk Static Routes from the AppleTalk Routing Menu.
2.
Press 1 to add a static route.
3.
Select the AppleTalk network type of the destination network.
4.
Enter the destination network range/number reachable through this static route.
5.
Enter the AppleTalk address of the Next Hop device, or, enter “0.0” if the Next Hop device is
over an unnumbered link.
over an unnumbered link.
6.
If you entered “0” for the AppleTalk address of the Next Hop device, enter the device name of
the Next Hop device. (Note that the device information for the Next Hop device must be
already configured. Refer to
the Next Hop device. (Note that the device information for the Next Hop device must be
already configured. Refer to
for instructions for
configuring device information.)
7.
Enter the number of hops for this route.
8.
Enter the zone name(s) of the remote network.
For an extended network, there will be a default zone name, and there will possibly be
additional zone names.
For an extended network, there will be a default zone name, and there will possibly be
additional zone names.
For nonextended networks, there will be a single zone name.