Cabletron Systems CSX1000 User Manual
Workgroup Remote Access Switch 499
T
RACE
M
ESSAGES
X.25 Trace Messages
Out - X25 Call Accept LCN <logical channel number>, <number of bytes> bytes
The DTE is accepting an SVC call.
The DTE is accepting an SVC call.
Out - X25 Call Request LCN <logical channel number>, <number of bytes> bytes
The DTE is attempting to place an SVC call.
The DTE is attempting to place an SVC call.
Out - X25 Clear Ind LCN <logical channel number>, <number of bytes> bytes
The DCE is clearing the X.25 Virtual circuit on the indicated LCN.
The DCE is clearing the X.25 Virtual circuit on the indicated LCN.
Out - X25 Clear Request LCN <logical channel number>, <number of bytes> bytes
The DTE is clearing the SVC call on the indicated LCN.
The DTE is clearing the SVC call on the indicated LCN.
Out - X25 CONNECTION REQUEST VcType=<virtual circuit type> ConnId=<connection Id>
Access=<access index> RemDteAddr=<x121 address or protocol/route id>
The system is sending a call request to the network.
Access=<access index> RemDteAddr=<x121 address or protocol/route id>
The system is sending a call request to the network.
Out - X25 CONNECTION RESPONSE ConnId=<connection Id> Access=<access index>
The system is sending a connection to the network. This is sent in response to receiving a call
indication.
The system is sending a connection to the network. This is sent in response to receiving a call
indication.
Out - X25 DATA LCN <logical channel number>, <number of bytes> bytes
Data transfer.
Data transfer.
Out - X25 DISCONNECT REQUEST ConnId=<connection Id> Access=<access index> Cause=<cause for
disconnect>
The system is sending a disconnect to the network to terminate a call.
disconnect>
The system is sending a disconnect to the network to terminate a call.
Out - X25 DISCONNECT RESPONSE ConnId=<connection Id> Access=<access index>
The system has received a disconnect response from the network.
The system has received a disconnect response from the network.
Out - X25 DTE Clear Conf LCN <logical channel number>, <number of bytes> bytes
The DTE is confirming that the virtual circuit on the indicated LCN has been cleared.
The DTE is confirming that the virtual circuit on the indicated LCN has been cleared.
Out - X25 DTE Interrupt LCN <logical channel number>, <number of bytes> bytes
An interrupt packet has been sent to the DCE. Flow control procedures do not apply to interrupt
packets.
An interrupt packet has been sent to the DCE. Flow control procedures do not apply to interrupt
packets.
Out - X25 DTE Intr Conf LCN <logical channel number>, <number of bytes> bytes
The DTE is confirming the reception of an interrupt packet from the DCE.
The DTE is confirming the reception of an interrupt packet from the DCE.
Out - X25 DTE REJ LCN <logical channel number>, <number of bytes> bytes
The DTE has detected a packet sequence error.
The DTE has detected a packet sequence error.
Out - X25 DTE Reset Conf LCN <logical channel number>, <number of bytes> bytes
The DTE is confirming that the virtual circuit has been reset.
The DTE is confirming that the virtual circuit has been reset.
Out - X25 DTE Restart Conf LCN <logical channel number>, <number of bytes> bytes
The DTE is confirming that all virtual circuits have been reset.
The DTE is confirming that all virtual circuits have been reset.
Out - X25 DTE RNR LCN <logical channel number>, <number of bytes> bytes
The DTE is not ready to receive more data packets.
The DTE is not ready to receive more data packets.