IBM 12.1(22)EA6 User Manual
6-16
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 6 Configuring IEEE 802.1x Port-Based Authentication
Configuring IEEE 802.1x Authentication
Configuring IEEE 802.1x Authentication Using a RADIUS Server
Beginning in privileged EXEC mode, follow these steps to configure IEEE 802.1x authentication with a
RADIUS server. The procedure is optional.
RADIUS server. The procedure is optional.
This example shows how to configure IEEE 802.1x using a RADIUS server:
Switch# configure terminal
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# dot1x reauthentication
Switch(config-if)# dot1x timeout reauth-period server
Enabling Periodic Re-Authentication
You can enable periodic IEEE 802.1x client re-authentication and specify how often it occurs. If you do
not specify a time period before enabling re-authentication, the number of seconds between
re-authentication attempts is 3600.
not specify a time period before enabling re-authentication, the number of seconds between
re-authentication attempts is 3600.
Beginning in privileged EXEC mode, follow these steps to enable periodic re-authentication of the client
and to configure the number of seconds between re-authentication attempts. This procedure is optional.
and to configure the number of seconds between re-authentication attempts. This procedure is optional.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface interface-id
Specify the port to be configured, and enter interface configuration mode.
Step 3
dot1x guest-vlan vlan-id
Specify an active VLAN as an IEEE 802.1x guest VLAN. The range is 1
to 4094.
to 4094.
You can configure any active VLAN except an RSPAN VLAN, or a voice
VLAN as an IEEE 802.1x guest VLAN.
VLAN as an IEEE 802.1x guest VLAN.
Step 4
dot1x reauthentication
Enable periodic re-authentication of the client, which is disabled by
default.
default.
Step 5
dot1x timeout reauth-period {seconds |
server}
server}
Set the number of seconds between re-authentication attempts.
The keywords have these meanings:
•
seconds—Sets the number of seconds from 1 to 65535; the default is
3600 seconds.
3600 seconds.
•
server—Sets the number of seconds as the value of the
Session-Timeout RADIUS attribute (Attribute[27]).
Session-Timeout RADIUS attribute (Attribute[27]).
This command affects the behavior of the switch only if periodic
re-authentication is enabled.
re-authentication is enabled.
Step 6
end
Return to privileged EXEC mode.
Step 7
show dot1x interface interface-id
Verify your IEEE 802.1x authentication configuration.
Step 8
copy running-config startup-config
(Optional) Save your entries in the configuration file.