IBM 12.1(22)EA6 User Manual

Page of 550
C H A P T E R
 
8-1
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
8
Configuring Smartports Macros
This chapter describes how to configure and apply Smartports macros on the Cisco Systems Intelligent 
Gigabit Ethernet Switch Module.
Note
For complete syntax and usage information for the commands used in this chapter, see the command 
reference for this release.
This chapter consists of these sections:
Understanding Smartports Macros
Smartports macros provide a convenient way to save and share common configurations. You can use 
Smartports macros to enable features and settings based on the location of a switch in the network and 
for mass configuration deployments across the network.
Each Smartports macro is a set of CLI commands that you define. Smartports macros do not contain new 
CLI commands; they are simply a group of existing CLI commands.
When you apply a Smartports macro on an interface, the CLI commands within the macro are configured 
on the interface. When the macro is applied to an interface, the existing interface configurations are not 
lost. The new commands are added to the interface and are saved in the running configuration file.
There are Cisco-default Smartports macros embedded in the switch software (see 
). You can 
display these macros and the commands they contain by using the show parser macro user EXEC 
command.
Table 8-1
Cisco-Default Smartports Macros
Macro Name
1
Description
cisco-global
Use this global configuration macro to enable load balancing across VLANs, provide 
rapid convergence of spanning-tree instances and to enable port error recovery.
cisco-desktop
Use this interface configuration macro for increased network security and reliability 
when connecting a desktop device, such as a PC, to a switch port.