IBM 12.1(22)EA6 User Manual

Page of 550
 
9-20
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 9      Configuring STP
Configuring Spanning-Tree Features
To return the interface to its default setting, use the no spanning-tree [vlan vlan-idcost interface 
configuration command. For information on how to configure load sharing on trunk ports by using 
spanning-tree path costs, see the 
.
Configuring the Switch Priority of a VLAN
You can configure the switch priority and make it more likely that the switch will be chosen as the root 
switch.
Note
Exercise care when using this command. For most situations, we recommend that you use the 
spanning-tree vlan vlan-id root primary and the spanning-tree vlan vlan-id root secondary global 
configuration commands to modify the switch priority.
Beginning in privileged EXEC mode, follow these steps to configure the switch priority of a VLAN. This 
procedure is optional.
To return the switch to its default setting, use the no spanning-tree vlan vlan-id priority global 
configuration command.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
spanning-tree vlan vlan-id priority priority
Configure the switch priority of a VLAN. 
For vlan-id, you can specify a single VLAN identified by 
VLAN ID number, a range of VLANs separated by a 
hyphen, or a series of VLANs separated by a comma. 
Valid interfaces include physical ports, VLANs, and port 
channels. The range is 1 to 4094.
For priority, the range is 0 to 61440 in increments of 
4096; the default is 32768. The lower the number, the 
more likely the switch will be chosen as the root switch. 
Valid priority values are 4096, 8192, 12288, 16384, 
20480, 24576, 28672, 32768, 36864, 40960, 45056, 
49152, 53248, 57344, and 61440. All other values are 
rejected.
Step 3
end
Return to privileged EXEC mode.
Step 4
show spanning-tree vlan vlan-id
Verify your entries.
Step 5
copy running-config startup-config
(Optional) Save your entries in the configuration file.