IBM 12.1(22)EA6 User Manual

Page of 550
 
11-11
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 11      Configuring Optional Spanning-Tree Features
Configuring Optional Spanning-Tree Features
Beginning in privileged EXEC mode, follow these steps to enable Port Fast. This procedure is optional.
Note
You can use the spanning-tree portfast default global configuration command to globally enable the 
Port Fast feature on all nontrunking ports.
To disable the Port Fast feature, use the spanning-tree portfast disable interface configuration 
command.
Enabling BPDU Guard
When you globally enable BPDU guard on ports that are Port Fast-enabled (the ports are in a Port 
Fast-operational state), spanning tree shuts down Port Fast-enabled ports that receive BPDUs.
In a valid configuration, Port Fast-enabled ports do not receive BPDUs. Receiving a BPDU on a Port 
Fast-enabled port signals an invalid configuration, such as the connection of an unauthorized device, and 
the BPDU guard feature puts the port in the error-disabled state. The BPDU guard feature provides a 
secure response to invalid configurations because you must manually put the port back in service. Use 
the BPDU guard feature in a service-provider network to prevent an access port from participating in the 
spanning tree.
Caution
Configure Port Fast only on ports that connect to end stations; otherwise, an accidental topology loop 
could cause a data packet loop and disrupt switch and network operation.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface interface-id
Specify an interface to configure, and enter interface 
configuration mode.
Step 3
spanning-tree portfast [trunk]
Enable Port Fast on an access port connected to a single 
workstation or server. By specifying the trunk keyword, you can 
enable Port Fast on a trunk port.
Note
To enable Port Fast on trunk ports, you must use the 
spanning-tree portfast trunk interface configuration 
command. The spanning-tree portfast command will 
not work on trunk ports.
Caution
Make sure that there are no loops in the network 
between the trunk port and the workstation or server 
before you enable Port Fast on a trunk port.
By default, Port Fast is disabled on all ports.
Step 4
end
Return to privileged EXEC mode.
Step 5
show spanning-tree interface interface-id 
portfast
Verify your entries.
Step 6
copy running-config startup-config
(Optional) Save your entries in the configuration file.