IBM 12.1(22)EA6 User Manual

Page of 550
 
12-6
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 12      Configuring VLANs
Configuring Normal-Range VLANs
are several adjacent switches that all have run out of spanning-tree instances. You can prevent this 
possibility by setting allowed lists on the trunk ports of switches that have used up their allocation 
of spanning-tree instances.
If the number of VLANs on the switch exceeds the number of supported spanning tree instances, we 
recommend that you configure the IEEE 802.1S Multiple STP (MSTP) on your switch to map 
multiple VLANs to a single STP instance. For more information about MSTP, see 
VLAN Configuration Mode Options
You can configure normal-range VLANs (with VLAN IDs 1 to 1005) by using these two configuration 
modes:
You access config-vlan mode by entering the vlan vlan-id global configuration command.
You access VLAN database configuration mode by entering the vlan database privileged EXEC 
command.
VLAN Configuration in config-vlan Mode
To access config-vlan mode, enter the vlan global configuration command with a VLAN ID. Enter a new 
VLAN ID to create a VLAN or with an existing VLAN ID to modify the VLAN. You can use the default 
VLAN configuration (
) or enter multiple commands to configure the VLAN. For more 
information about commands available in this mode, see the vlan global configuration command 
description in the command reference for this release. When you have finished the configuration, you 
must exit config-vlan mode for the configuration to take effect. To display the VLAN configuration, 
enter the show vlan privileged EXEC command.
You must use this config-vlan mode when creating extended-range VLANs (VLAN IDs greater than 
1005). See the 
.
VLAN Configuration in VLAN Configuration Mode
To access VLAN configuration mode, enter the vlan database privileged EXEC command. Then enter 
the vlan command with a new VLAN ID to create a VLAN or with an existing VLAN ID to modify the 
VLAN. You can use the default VLAN configuration (
) or enter multiple commands to 
configure the VLAN. For more information about keywords available in this mode, see the vlan VLAN 
configuration command description in the command reference for this release. When you have finished 
the configuration, you must enter apply or exit for the configuration to take effect. When you enter the 
exit command, it applies all commands and updates the VLAN database. VTP messages are sent to other 
switches in the VTP domain, and the privileged EXEC mode prompt appears.