IBM 12.1(22)EA6 User Manual

Page of 550
 
13-4
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 13      Configuring VTP
Understanding VTP
VTP advertisements distribute this global domain information:
VTP domain name
VTP configuration revision number
Update identity and update timestamp
MD5 digest VLAN configuration, including maximum transmission unit (MTU) size for each 
VLAN.
Frame format
VTP advertisements distribute this VLAN information for each configured VLAN:
VLAN IDs 
VLAN name
VLAN type
VLAN state
Additional VLAN configuration information specific to the VLAN type
VTP Version 2
If you use VTP in your network, you must decide whether to use version 1 or version 2. By default, VTP 
operates in version 1.
VTP version 2 supports these features not supported in version 1:
Token Ring support—VTP version 2 supports Token Ring Bridge Relay Function (TrBRF) and 
Token Ring Concentrator Relay Function (TrCRF) VLANs. For more information about Token 
Ring VLANs, see th
.
Unrecognized Type-Length-Value (TLV) support—A VTP server or client propagates 
configuration changes to its other trunks, even for TLVs it is not able to parse. The unrecognized 
TLV is saved in NVRAM when the switch is operating in VTP server mode.
Version-Dependent Transparent Mode—In VTP version 1, a VTP transparent switch inspects VTP 
messages for the domain name and version and forwards a message only if the version and domain 
name match. Because VTP version 2 supports only one domain, it forwards VTP messages in 
transparent mode without inspecting the version and domain name.
Consistency Checks—In VTP version 2, VLAN consistency checks (such as VLAN names and 
values) are performed only when you enter new information through the CLI or SNMP. Consistency 
checks are not performed when new information is obtained from a VTP message or when 
information is read from NVRAM. If the MD5 digest on a received VTP message is correct, its 
information is accepted.
VTP Pruning
VTP pruning increases network available bandwidth by restricting flooded traffic to those trunk links 
that the traffic must use to reach the destination devices. Without VTP pruning, a switch floods 
broadcast, multicast, and unknown unicast traffic across all trunk links within a VTP domain even 
though receiving switches might discard them. VTP pruning is disabled by default.