IBM 12.1(22)EA6 User Manual

Page of 550
 
14-5
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 14      Configuring IGMP Snooping and MVR
Understanding IGMP Snooping
the message is not flooded to other ports on the switch. Any known multicast traffic is forwarded to the 
group and not to the CPU. Any unknown multicast traffic is flooded to the VLAN and sent to the CPU 
until it becomes known.
Figure 14-2
Second Host Joining a Multicast Group
Leaving a Multicast Group
The router sends periodic multicast general queries and the switch forwards these queries through all 
ports in the VLAN. Interested hosts respond to the queries. If at least one host in the VLAN wishes to 
receive multicast traffic, the router continues forwarding the multicast traffic to the VLAN. The switch 
forwards multicast group traffic to only those hosts listed in the forwarding table for that Layer 2 
multicast group. 
When hosts want to leave a multicast group, they can either silently leave, or they can send a leave 
message. When the switch receives a leave message from a host, it sends a group-specific query to 
determine if any other devices connected to that interface are interested in traffic for the specific 
multicast group. The switch then updates the forwarding table for that MAC group so that only those 
hosts interested in receiving multicast traffic for the group are listed in the forwarding table. If the router 
receives no reports from a VLAN, it removes the group for the VLAN from its IGMP cache.
Table 14-2
Updated IGMP Snooping Forwarding Table
Destination Address
Type of Packet
Ports
0100.5exx.xxxx
IGMP
0
0100.5e01.0203
!IGMP
1, 2, 5
Forwarding
table
CPU
Server
Blade 1
Server
Blade 2
Server
Blade 3
Server
Blade 4
Router A
IGESM
Switching engine
1
0
2
3
4
5
92422