IBM 12.1(22)EA6 User Manual

Page of 550
 
15-4
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 15      Configuring Port-Based Traffic Control
Configuring Port Security
Beginning in privileged EXEC mode, follow these steps to define a port as a protected port:
To disable protected port, use the no switchport protected interface configuration command.
This example shows how to configure a port as a protected port:
Switch# configure terminal
Switch(config)# interface gigabitethernet0/17
Switch(config-if)# switchport protected
Switch(config-if)# end
Configuring Port Security
Note
You cannot configure port security on the internal 100 Mbps management module ports.
You can use the port security feature to restrict input to an interface by limiting and identifying MAC 
addresses of the stations allowed to access the port. When you assign secure MAC addresses to a secure 
port, the port does not forward packets with source addresses outside the group of defined addresses.
This section includes information about these topics:
Understanding Port Security
This section includes information about:
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface interface-id
Specify the interface to configure, and enter interface 
configuration mode.
Step 3
switchport protected
Configure the interface to be a protected port.
Step 4
end
Return to privileged EXEC mode.
Step 5
show interfaces interface-id switchport
Verify your entries.
Step 6
copy running-config startup-config
(Optional) Save your entries in the configuration file.