IBM 12.1(22)EA6 User Manual

Page of 550
 
18-11
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 18      Configuring SPAN and RSPAN
Configuring SPAN
Removing Ports from a SPAN Session
Beginning in privileged EXEC mode, follow these steps to remove a port as a SPAN source for a session:
To remove a source or destination port from the SPAN session, use the no monitor session 
session_number source interface interface-id global configuration command or the no monitor session 
session_number destination interface interface-id global configuration command. To change the 
encapsulation type back to the default (native), use the monitor session session_number destination 
interface
 interface-id without the encapsulation keyword.
This example shows how to remove a port as a SPAN source for SPAN session 1:
Switch(config)# no monitor session 1 source interface gigabitethernet0/17
Switch(config)# end
This example shows how to disable received traffic monitoring on a port that was configured for 
bidirectional monitoring:
Switch(config)# no monitor session 1 source interface gigabitethernet0/17 rx
The monitoring of traffic received on port 1 is disabled, but traffic sent from this port continues to be 
monitored.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
no monitor session session_number source 
interface
 interface-id [, | -] [both | rx | tx]
Specify the characteristics of the source port (monitored port) and 
SPAN session to remove.
For session, specify 1.
For interface-id, specify the source port to no longer monitor. Valid 
interfaces include physical interfaces and port-channel logical 
interfaces (port-channel port-channel-number).
(Optional) Use [, | -] to specify a series or range of interfaces if they 
were configured. This option is valid when monitoring only 
received traffic. Enter a space before and after the comma; enter a 
space before and after the hyphen.
(Optional) Specify the direction of traffic (bothrx, or tx) to no 
longer monitor. If you do not specify a traffic direction, both 
transmit and receive are disabled.
Step 3
end
Return to privileged EXEC mode.
Step 4
show monitor [session session_number]
Verify your entries.
Step 5
copy running-config startup-config
(Optional) Save your entries in the configuration file.