IBM 12.1(22)EA6 User Manual

Page of 550
 
23-23
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 23      Configuring QoS
Configuring Standard QoS
Configuring a QoS Policy
Configuring a QoS policy typically requires classifying traffic into classes, configuring policies applied 
to those traffic classes, and attaching policies to interfaces.
For background information, see the 
 and th
.
This section contains this configuration information:
Classifying Traffic by Using ACLs
You can classify IP traffic by using IP standard or IP extended ACLs; you can classify Layer 2 traffic 
by using Layer 2 MAC ACLs.
Beginning in privileged EXEC mode, follow these steps to create an IP standard ACL for IP traffic:
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
access-list access-list-number {permit 
remark} {source source-wildcard | host 
source any}
Create an IP standard ACL, repeating the command as many times as 
necessary.
For access-list-number, enter the ACL number. The range is 1 to 99 and 
1300 to 1999.
Enter permit to specify whether to permit access if conditions are 
matched.
Enter remark to specify an ACL entry comment up to 100 characters. 
Note
Deny statements are not supported for QoS ACLs. See the 
 for 
more details.
The source is the source address of the network or host from which the 
packet is being sent, specified in one of three ways:
The 32-bit quantity in dotted decimal format.
The keyword any as an abbreviation for source and 
source-wildcard
 of 0.0.0.0 255.255.255.255. You do not need to 
enter a source wildcard.
The keyword host as an abbreviation for source and 
source-wildcard of source 0.0.0.0.
(Optional) The source-wildcard variable applies wildcard bits to the 
source (see first bullet item).
Step 3
end
Return to privileged EXEC mode.
Step 4
show access-lists
Verify your entries.
Step 5
copy running-config startup-config
(Optional) Save your entries in the configuration file.