IBM 12.1(22)EA6 User Manual
23-33
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 23 Configuring QoS
Configuring Standard QoS
Configuring the DSCP-to-CoS Map
You use the DSCP-to-CoS map to map DSCP values in incoming packets to a CoS value, which is used
to select one of the four egress queues.
to select one of the four egress queues.
The switch supports these DSCP values: 0, 8, 10, 16, 18, 24, 26, 32, 34, 40, 46, 48, and 56.
shows the default DSCP-to-CoS map.
If these values are not appropriate for your network, you need to modify them.
Beginning in privileged EXEC mode, follow these steps to modify the DSCP-to-CoS map:
To return to the default map, use the no mls qos map dscp-cos global configuration command.
Table 23-8
Default DSCP-to-CoS Map
DSCP Values
CoS Value
0
0
8, 10
1
16, 18
2
24, 26
3
32, 34
4
40, 46
5
48
6
56
7
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
mls qos map dscp-cos dscp-list to cos
Modify the DSCP-to-CoS map.
For dscp-list, enter up to 13 DSCP values separated by spaces. Then enter
the to keyword.
the to keyword.
For cos, enter the CoS value to which the DSCP values correspond.
The supported DSCP values are 0, 8, 10, 16, 18, 24, 26, 32, 34, 40, 46, 48,
and 56. The CoS range is 0 to 7.
and 56. The CoS range is 0 to 7.
Step 3
end
Return to privileged EXEC mode.
Step 4
show mls qos maps dscp-cos
Verify your entries.
Step 5
copy running-config startup-config
(Optional) Save your entries in the configuration file.