IBM 12.1(22)EA6 User Manual

Page of 550
 
4-18
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 4      Administering the Switch
Managing the MAC Address Table
Configuring a Login Banner
You can configure a login banner to be displayed on all connected terminals. This banner appears after 
the MOTD banner and before the login prompt.
Beginning in privileged EXEC mode, follow these steps to configure a login banner:
To delete the login banner, use the no banner login global configuration command.
This example shows how to configure a login banner for the switch by using the dollar sign ($) symbol 
as the beginning and ending delimiter:
Switch(config)# banner login $
Access for authorized users only. Please enter your username and password.
$
Switch(config)#
Managing the MAC Address Table
The MAC address table contains address information that the switch uses to forward traffic between 
ports. All MAC addresses in the address table are associated with one or more ports. The address table 
includes these types of addresses: 
Dynamic address: a source MAC address that the switch learns and then ages when it is not in use.
Static address: a manually entered unicast or multicast address that does not age and that is not lost 
when the switch resets.
The address table lists the destination MAC address, the associated VLAN ID, and port number 
associated with the address. 
Note
For complete syntax and usage information for the commands used in this section, see the command 
reference for this release.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
banner login c message c
Specify the login message.
For c, enter the delimiting character of your choice, for example, a pound 
sign (#), and press the Return key. The delimiting character signifies the 
beginning and end of the banner text. Characters after the ending delimiter 
are discarded.
For message, enter a login message up to 255 characters. You cannot use the 
delimiting character in the message.
Step 3
end
Return to privileged EXEC mode.
Step 4
show running-config
Verify your entries.
Step 5
copy running-config startup-config
(Optional) Save your entries in the configuration file.