Cabletron Systems 3H08-04 User Manual

 

This chapter provides reference material and instructions that network 
administrators can use to configure the Fast Ethernet Switch Modules.

For instructions on adding a switch module to the ATX, see Chapter 5, 

 

.

 

Watch the LED sequence during power-up. It takes about 1 minute for the 
ATX to complete the power-up diagnostics. The ATX begins system 
diagnostics on the PPE (topmost module) and then individually on each 
installed module, starting at the top and working down to the bottom.

Using both processors, the specific power-up tests run on the switch 
module are:

•

ROM checksum test

•

Instruction memory test

•

Memory map tests

•

Interrupt tests

•

Fast Ethernet data loopback tests

The power-up LED sequence for the Fast Ethernet module is as follows:

1. All LEDs flash.

2. The PWR LED remains on, and the TX LEDs flash.

3. On each switch module, the following occurs:

a.

The PROC LED comes on for 5 seconds, blinks, then remains lit.

b. The RX and TX LEDs flash momentarily.