Cisco Systems WSC2960S24TSSRF User Manual
2-22
Catalyst 2960-S Switch Hardware Installation Guide
OL-19732-04
Chapter 2 Switch Installation
Connecting to SFP and SFP+ Modules
Step 3
Insert a dust plug into the optical ports of the SFP or SFP+ module to keep the optical interfaces clean.
Step 4
If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the latch is
obstructed and you cannot use your finger, use a small, flat-blade screwdriver or other long, narrow
instrument to open the latch.
obstructed and you cannot use your finger, use a small, flat-blade screwdriver or other long, narrow
instrument to open the latch.
Step 5
Grasp the SFP or SFP+ module, and carefully remove it from the module slot.
Step 6
Place the module in an antistatic bag or other protective environment.
Connecting to SFP and SFP+ Modules
For instructions on how to connect to fiber-optic SFP modules, see the
see the
section.
For instructions about how to install or remove an SFP module, see the
Connecting to Fiber-Optic SFP and SFP+ Modules
Warning
Class 1 laser product. Statement 1008
Caution
Do not remove the rubber plugs from the SFP or SFP+ module port or the rubber caps from the
fiber-optic cable until you are ready to connect the cable. The plugs and caps protect the SFP module
ports and cables from contamination and ambient light.
fiber-optic cable until you are ready to connect the cable. The plugs and caps protect the SFP module
ports and cables from contamination and ambient light.
Before connecting to the SFP module, be sure that you understand the port and cabling stipulations in
the
the
. See
SFP module.
Step 1
Remove the rubber plugs from the module port and fiber-optic cable, and store them for future use.
Step 2
Insert one end of the fiber-optic cable into the SFP or SFP+ module port (see
).