Cisco Systems N5KC5548UPFA User Manual
S e n d d o c u m e n t a t i o n c o m m e n t s t o n e x u s 5 k d o c s @ c i s c o . c o m .
3-6
Cisco Nexus 5500 Platform and Cisco Nexus 5000 Platform Hardware Installation Guide
OL-15902-01
Chapter 3 Connecting the Switch
Connecting to an Ethernet Port
Figure 3-2
Alternate Removal Method for Bale Clasp SFP+ Transceivers
Step 4
Insert a dust cover into the port end of the transceiver and place the transceiver on an antistatic mat or
into a static shielding bag if you plan to return it to the factory.
into a static shielding bag if you plan to return it to the factory.
Step 5
Install a replacement transceiver (see the
). If
another transceiver is not being installed, protect the optical cage by inserting a clean cover.
Installing Cables into SFP+ Transceivers
Caution
To prevent damage to the copper cables, do not place more tension on them than the rated limit and do
not bend to a radius of less than 1 inch (2.54 cm) if there is no tension in the cable, or 2 inches (5.08 cm)
if there is tension in the cable.
not bend to a radius of less than 1 inch (2.54 cm) if there is no tension in the cable, or 2 inches (5.08 cm)
if there is tension in the cable.
This section includes the following topics:
•
•
Installing a Cable into an SFP+ Transceiver
Caution
To prevent possible damage to the cable or transceiver, install the transceiver in the port before installing
the cable in the transceiver.
the cable in the transceiver.
To install a cable into a transceiver, follow these steps:
Step 1
Attach an ESD-preventive wrist strap and follow its instructions for use.
186903